Homemade Onion Rings

I got this recipe here http://allrecipes.com//Recipe/old-fashioned-onion-rings/Detail.aspx

I had bought a package of onion ring mix and we made those but then we new that wouldnt be enough so i quickly jumped on the internet and found this recipe! They were really good. However it was almost to much breading on the outside but i liked them a lot more than the packaged mix i bought. Just know they arent like when you get onion rings out at a restaurant but very good!

You will need:

• 1 large onion, cut into 1/4-inch slices
• 1 1/4 cups all-purpose flour
• 1 teaspoon baking powder
• 1 teaspoon salt
• 1 egg
• 1 cup milk, or as needed
• 3/4 cup dry bread crumbs
• seasoned salt to taste
• 1 quart oil for frying, or as needed

Directions:

1. Heat the oil in a deep-fryer to 365 degrees F (185 degrees C).
2. Separate the onion slices into rings, and set aside. In a small bowl, stir together the flour, baking powder and salt.
3. Dip the onion slices into the flour mixture until they are all coated; set aside. Whisk the egg and milk into the flour mixture using a fork. Dip the floured rings into the batter to coat, then place on a wire rack to drain until the batter stops dripping. The wire rack may be placed over a sheet of aluminum foil for easier clean up. Spread the bread crumbs out on a plate or shallow dish. Place rings one at a time into the crumbs, and scoop the crumbs up over the ring to coat. Give it a hard tap as you remove it from the crumbs. The coating should cling very well. Repeat with remaining rings.
4. Deep fry the rings a few at a time for 2 to 3 minutes, or until golden brown. Remove to paper towels to drain. Season with seasoning salt, and serve.

Enjoy!!